|
|
|
|
|
|
|
|
|
|
|
|
|
Modules selection
For further information, please click on the item number
M007 3-Channel music light
Music light with 3 pre-fixed channels. The module creates a special play of light full of life.
M008 Flasher 230V~
Electronic flasher unit for glow lamps up to max. 600 Watt, 230 Volt~.
M009 Light flasher 230V~
...flashes glow lamps 230V~ approx. 15...200 times per minute.
M011N 4-Channel running light 230V~
This running light makes 4 lamps or lamp groups light up one after the other at regular intervals and go out again.
M012 Motor and lamp controller (Dimmer) 240V~ / 110V~, max. 1200W / 600W
...regulates incandescent lamps, heaters, hand drills, etc. via a potentiometer.
M013 Twilight switch
This electronic twilight switch connects automatically by means of an installed relay lamps at nightfall and off again at daybreak.
M015N Potential transformer, adjustable, max. 1.5A, input: 6...28V= output: 3...15V=
The input voltage must be at least 3V higher than the adjusted output voltage.
M016 Loudspeaker separating filter 3-way 4...8 Ohm, max. 120W
For one bass speaker, mid speaker and one till two tweeter.
M019 Automatic light switch 230V~ time switch approx. 1 sec. to approx. 15 min.
....connects other devices by means of the installed, potential-free relay point 1 x change over (max. 3A) after key depression and disconnects them again automatically at the end of the adjusted time.
M020 Voltage Transformer from 24 V= to approx. 13.8 V= (for 12 V= devices), max. 1.1 A
With the aid of this module it is feasible to operate 12V= devices at 24V=-lorry-, ships-, and machine batteries.
M026 Solar power converter
This converter supplies by an input voltage of 0,9...3V (max. 10V) a controlled output voltage of approx. 15V (variable).
M028 Output regulator 110...240V~ 2600VA
Control of resistive + inductive loads (e.g. motors, heatings, incandescent lamps, etc., if they are phase-controllable).
M028N Power Control 110...240V~ 4000VA
For controlling ohmic + inductive loads (e.g. motors, heatings, incandescent lamps, etc. if these can be regulated in phase control).
M029 Voltage converter input: 6...14V=, output: 11...26V=
This electronically controllable DC voltage converter transforms a low input voltage in to a nearly twice as high output voltage.
| 1 2 3 4 5 6 7 | next page >> |
You are the visitor no.
of this page.