Soldering course

Soldering course - page 5

Prior to fitting the circuit board with the components these must be bent according to the grid on the board. Should the component be longer than the distance between 2 holes it has to be inserted vertically.
To avoid any damage to the components bend it as shown in the picture.

ANOTE: Do not cut off the ends of the wire prior to the soldering.

soldering presentation shortform

<< previous page

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

next page >>

You are the visitor no. of this page.